Aqualarm V2 Manual English
Read this manual carefully and keep it for subsequent use. AQUALARM is an alarm system that detects the immersion of a body in a pool pursuant. Bruce Roberts, steel boat plans, boat building, boatbuilding, steel boat kits, boat. Trawler Yacht 4. Sister vessels have been approved for CE.
User Manual AQUALARM V2 - This User Manual - also called owner's manual or operating instructions - contains all information for the user to make full use of the product. This manual includes a description of the functions and capabilities and presents instructions as step-by-step procedures. Error codes and the Reference manual can also be included. This document contains important information to use and/or repair your appliance. Depending on the nature of the manual (use, installation, service, parts list), it provides instructions that you can't ignore. We provide PDF manuals: easy to download, the documents can be displayed on any equipment like mobile, tablet and computer. This is an official document edited by the manufacturer or a local distributor.
Enter your email: Download >Electronic file ready for instant download (US$ 12.90).
Applications It gives an alert whenever there is water on the floor and avoids serious 'water damage'. It is installed in places such as: • Cellar, car park, pumping room, • boiler room, laundry room, kitchen, • pool filtration room, control room, computer room, etc. Introduction & Functions Fully static in design for total reliability, it consists of an Electronics Receiverwhich delivers a 24 Vrms security voltage to power the Sensorwhich is placed on the ground. X11 Video Output Xcb Download Games.
If the water (or conductive liquid) touches the Sensor, the Electronic Receiver relay trips and its changeover contact generates an alarm, a signal or a command. The Electronics Receiver is placed in an IP65 PVC housing: There are three versions, one of which has an integrated Buzzer for acoustic signalling.
All three AQUALARM versions come with ONE 'Single Sensor 213 647' with two metres of cable The Sensor must be installed on the test surface - there are two types: SINGLE sensor 213 647, consisting of a brass feeder and a 2 metre run of wire: it detects at a specific point (option to connect several sensors in parallel, see page 2/2). BRAID sensor 216 727, sold by the metre run: whatever the portion of the braid affected, the presence of water is detected. Optionally, a remote Horn can be provided (220V bell).